ASTM A/AM: Standard Specification for Stainless Steel Spring Wire. Copper. % max. Phosphorus% max Nickel. – %. Silicon. % max Nitrogen% max. Tensile Strength Table (ASTM-A) *KSI. Over. Stainless Steel Wire, AISI / ASTM A , Cr % Ni %, 28 () , 10 (), , C, Request a Quote. AISI ASTM A , Cr
|Published (Last):||12 May 2013|
|PDF File Size:||6.42 Mb|
|ePub File Size:||19.93 Mb|
|Price:||Free* [*Free Regsitration Required]|
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. After this treatment, the specimen coil shall show uniform pitch with no splits or fractures.
ASTM A AM – 98 Stainless Steel Spring Wire_百度文库
After this treatment, the specimen coil shall show uniform pitch with no splits or fractures. Within the text and tables, the SI units are shown in brackets. Your comments are invited either for revision of this standard or for additional standards and should a133 addressed to ASTM International Headquarters. Originally approved in This standard has been approved for use by agencies of the Department of Defense.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?
B Maximum unless range is shown.
Stainless Steel 302
Stainless steel wire m One specimen shall be taken from every ten coils in the lot. Current edition approved May 10, NOTE 1—A typical ordering description is as follows: Call awtm to see how we can solve your stainless steel spring manufacturing challenge.
Historical Version s – view previous versions of standard. A piece not more than 10 in.
Stainless Steel Wire Springs
Stainless Steel Wire Springs For over 85 years, General Wire Spring has offered compression springs, extension springs, torsion spring, and wire forms manufactured using stainless steel spring wire. Our staff has the experience to assist you in selecting the best stainless steel alloy for your application and to manufacture a custom spring steel wire that meets or exceeds your expectations.
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. Such requirements may include, but are not limited to a331 following: Click here to contact us today or call us at The wire shall withstand the minimum number of bends speci?
The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. These specimens shall be tested in a bending machine conforming substantially to Fig. General Requirements for Delivery 4.
This abstract is a brief summary of aetm referenced standard. Following fabrication Type and Grade XM shall be age or precipitation hardened to produce their maximum strength properties. NOTE 1—A typical ordering description is as follows: It has superior cold forming properties and exhibits short term tensile and creep strength at temperatures up to degrees F.
This standard has been approved for use by agencies of the Department of Defense. Such requirements may include, but are not limited to the following: Within the text and tables, the SI units are shown in brackets. Go to Navigation Go to Content.
ASTM A / AM – 03 Standard Specification for Stainless Steel Spring Wire
Lubricating coatings, which are insoluble in acid etch solution, shall be removed before etching. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm. The steel shall conform to the required chemical composition for carbon, manganese, phosphorus, sulfur, silicon, chromium, nickel, molybdenum, nitrogen, and other elements.
Following fabrication Type and Grade XM shall be age or precipitation hardened to produce their maximum strength properties.